AMETEK XG Family Programmable DC - Manual (Page 241)

Communications Options
M370430-01 Rev E 6-35
6
Setting a Static IP Address through Ethernet, USB,
Serial Interfaces
Ethernet
Use the AMETEK LXI Discovery Browser to locate the power
supply and determine the IP address. This address will be entered
into the Host field of the Ethernet Test Utility. The Port field
should be set to the default of 5025.
As you can see, the power supply was initially in DHCP mode due
to the response of my query, SYST:COMM:LAN:ADDR?, being
“0.0.0.0”
To set a static IP address, use the following command,
SYST:COMM:LAN:ADDR “N” where N will be the IP address
of your choice. Query the command SYST:COMM:LAN:ADDR?
to verify the static IP address has been set.
Following these steps the static IP address is now set.