AMETEK XG Family Programmable DC - Manual (Page 52)

Local Operation
3-6 M370430-01 Rev E
Normal Display Mode and Inactivity Timeout
Normal display mode appears on the output voltage and current displays
when the configuration changes from the front panel have been
completed or when the inactivity timeout occurs (default is 3 seconds).
Normal display mode shows the output voltage and current values.
If a timeout occurs before the changes made to the value have been set,
the changes will not be saved and you will have to re-enter the changes.
The inactivity timeout is variable from 1 to 20 seconds and can only be
changed using the SCPI command.
The SCPI command (s) for these instructions are:
[:]SYSTem[<channel>]:FPANel[:TIMeout]
Important: Each user memory setting location stores the timeout so that
beginning users and expert users are not required to use the same timeout