H3C Technologies H3C S7500E Series Switches - Manual (Page 220)

15-12
Host A and Host C belong to Department A, and access the enterprise network through different
devices. Host B and Host D belong to Department B. They also access the enterprise network
through different devices.
To ensure communication security and avoid broadcast storms, VLANs are configured in the
enterprise network to isolate Layer 2 traffic of different departments. VLAN 100 is assigned to
Department A, and VLAN 200 is assigned to Department B.
Ensure that hosts within the same VLAN can communicate with each other, that is, Host A can
communicate with Host C, and Host B can communicate with Host D.
Figure 15-5 Network diagram for port-based VLAN configuration
Configuration procedure
1) Configuration on Device A
# Create VLAN 100, and assign port GigabitEthernet 2/0/1 to VLAN 100.
<DeviceA> system-view
[DeviceA] vlan 100
[DeviceA-vlan100] port gigabitethernet 2/0/1
[DeviceA-vlan100] quit
# Create VLAN 200, and assign port GigabitEthernet 2/0/2 to VLAN 200.
[DeviceA] vlan 200
[DeviceA-vlan200] port gigabitethernet 2/0/2
[DeviceA-vlan200] quit
# Configure port GigabitEthernet 2/0/3 as a trunk port, and assign it to VLANs 100 and 200, thus
enabling GigabitEthernet 2/0/3 to forward traffic of VLANs 100 and 200 to Device B.
[DeviceA] interface gigabitethernet 2/0/3
[DeviceA-GigabitEthernet2/0/3] port link-type trunk
[DeviceA-GigabitEthernet2/0/3] port trunk permit vlan 100 200
Please wait... Done.
[DeviceA-GigabitEthernet2/0/3] quit
2) Configure Device B as you configure Device A.
3) Configure Host A and Host C to be on the same network segment, 192.168.100.0/24 for example.
Configure Host B and Host D to be on the same network segment, 192.168.200.0/24 for example
Verification
1) Host A and Host C and ping each other successfully, but they both fail to ping Host B. Host B and
Host D and ping each other successfully, but they both fail to ping Host A.
2) Check whether the configuration is successful by displaying relevant VLAN information.
# Display information about VLANs 100 and 200 on Device A.
[DeviceA] display vlan 100