H3C Technologies H3C S7500E Series Switches - Manual (Page 235)

15-27
To do… Use the command… Remarks
Enter port group
view
port-group manual
port-group-name
In port group view, the
subsequent configurations
apply to all ports in the port
group.
In Layer 2 aggregate
interface view, the
subsequent configurations
apply to the Layer 2
aggregate interface and all its
member ports.
Configure port link type as hybrid port link-type hybrid Required
Configure the hybrid port(s) to permit
the specified IP subnet-based VLANs
to pass through
port hybrid vlan vlan-id-list
{ tagged | untagged }
Required
Associate the hybrid port(s) with the
specified IP subnet-based VLAN
port hybrid ip-subnet-vlan
vlan vlan-id
Required
After you configure a command on a Layer 2 aggregate interface, the system starts applying the
configuration to the aggregate interface and its aggregation member ports. If the system fails to do that
on the aggregate interface, it stops applying the configuration to the aggregation member ports. If it
fails to do that on an aggregation member port, it simply skips the port and moves to the next port.
Displaying and Maintaining VLAN
To do... Use the command… Remarks
Display VLAN information
display vlan [ vlan-id1 [ to vlan-id2 ] | all |
dynamic | interface interface-type
interface-number.subnumber | reserved |
static ]
Available in any view
Display VLAN interface
information
display interface vlan-interface
[ vlan-interface-id ]
Available in any view
Display hybrid ports or trunk ports
on the device
display port { hybrid | trunk } Available in any view