H3C Technologies H3C S7500E Series Switches - Manual (Page 260)

19-2
Hold timer –– When a GARP application entity receives the first registration request, it starts a
hold timer and collects succeeding requests. When the timer expires, the entity sends all these
requests in one Join message. This helps you save bandwidth.
Join timer –– A GARP participant sends each Join message at most twice for reliability sake and
uses a join timer to set the sending interval. If the first Join message has not been acknowledged
before the Join timer expires, the GARP participant sends the second Join message.
Leave timer –– Starts upon receipt of a Leave message sent for deregistering some attribute
information. If no Join message has been received before this timer expires, the GARP participant
removes the attribute information as requested.
LeaveAll timer –– Starts when a GARP participant starts. When this timer expires, the entity sends
a LeaveAll message so that other participants can re-register its attribute information. Then, a
LeaveAll timer starts again.
The settings of GARP timers apply to all GARP applications, such as GVRP, on a LAN.
Unlike other three timers, which are set on a port basis, the LeaveAll timer is set in system view
and takes effect globally.
A GARP participant may send LeaveAll messages at the interval set by its LeaveAll timer or the
LeaveAll timer on another device on the network, whichever is smaller. This is because each time
a device on the network receives a LeaveAll message it resets its LeaveAll timer.
Operating mechanism of GARP
The GARP mechanism allows the configuration of a GARP participant to propagate throughout a LAN
quickly. In GARP, a GARP participant registers or deregisters its attributes with other participants by
making or withdrawing declarations of attributes and at the same time, based on received declarations
or withdrawals, handles attributes of other participants. When a port receives an attribute declaration, it
registers the attribute; when a port receives an attribute withdrawal, it deregisters the attribute.
GARP participants send protocol data units (PDU) with a particular multicast MAC address as
destination. Based on this address, a device can identify to which GVRP application (GVRP for
example) a GARP PDU should be delivered.
GARP message format
The following figure illustrates the GARP message format.