Canon imagePROGRAF TX-3100 36" Printer with Basket - Manual (Page 339)

Detect image size and Oversize
Operation is as described below when both Detect image size and Oversize are specified.
• When OFF or Command priority is selected for Detect image size and Disable is selected for •
Oversize:
Oversize is disabled in accordance with the command-specified image drawing range.
Margins are added within the command-specified image drawing range.
Depending on the layout, part of the image may be cut off.
• When OFF or Command priority is selected for Detect image size and Enable is selected for •
Oversize:
Oversize is enabled in accordance with the command-specified image drawing range.
Margins are added outside the command-specified image drawing range.
The image is not cut off by the margins.
However, you will need to print on paper of a size that is greater than the size of the image drawing
range specified by the HP-GL/2 data plus the top, bottom, left, and right margins.
• When Detected size is selected for Detect image size and Disable is selected for Oversize: •
Oversize is disabled and processing of the detected minimum image range is performed.
Margins are added within the detected minimum image range and parts of the image are cut off.
• When Detected size is selected for Detect image size and Enable is selected for Oversize: •
Oversize is enabled and processing of the detected minimum image range is performed.
Margins are added outside the detected minimum image range.
The image is not cut off by the margins.
Detect image size AND Oversize EXAMPLE
The example below shows printing of data in which a figure is located in the upper left corner
with margins below and to the right, on roll paper that is larger than the command-specified image
drawing range (size normally specified by the application).
A. Command-specified image drawing range (when OFF or Command priority is selected for Detect
image size )
B. Minimum image range detected (when Detected size is selected for Detect image size )
339