0 heart rate alarm test, Heart rate alarm test -19 – ZOLL R Series Monitor Defibrillator Rev J User Manual
Page 29
R Series Service Manual
9650-0903-01 Rev. J
1-
19
10.0 Heart Rate Alarm Test
Tools Needed:Impulse 4000.
Do this...
Observe this...
Pass Fail/NA
10.1
Turn the selector switch to MONITOR mode( for
AED units turn to ON.)
Connect the ECG leads to the Impulse 4000.
Set the simulator to 120 BPM and the
defibrillator to lead II.
Lead II waveform displayed on monitor.
NSR ECG at 120 BPM +/- 2 displayed.
o
o
o
10.2
Press ALARMS softkey.
The alarm menu displays.
o
o
o
10.3
Press NEXT PARAM softkey until ECG HR
displays.
Cursor scrolls through parameters.
o
o
o
10.4
Press CHANGE VALUE softkey.
o
o
o
10.5
Press INC> softkey for state.
Cursor scrolls through ENABLE, AUTO and DISABLE.
o
o
o
10.6
Press DEC< softkey for state.
Cursor scrolls through ENABLE, DISABLE, AND AUTO.
o
o
o
10.7
Press INC> softkey until ENABLE displays.
ENABLE displays.
o
o
o
10.8
Press ENTER softkey.
o
o
o
10.9
Press NEXT FIELD softkey to select the heart
rate limit.
Cursor scrolls to Low field.
o
o
o
10.10
Press CHANGE VALUE softkey and press
INC> or DEC< to set low heart rate limit to 30.
o
o
o
10.11
Press ENTER softkey.
o
o
o
10.12
Press NEXT FIELD softkey to select the high
heart rate limit.
Cursor scrolls to High field.
o
o
o
10.13
Press CHANGE VALUE and press INC< or
DEC> softkey and set high heart rate limit to
150.
o
o
o
10.14
Press ENTER softkey, then press RETURN
softkey.
o
o
o
10.15
Press ALARM SUSPEND button.
No alarm sounds.
o
o
o