ZOLL R Series Monitor Defibrillator Rev J - Manual (Page 477)

Transferring Full Disclosure Files Through Wi-Fi (Optional)
9650-0912-01 Rev. K ZOLL R Series Operator’s Guide 11–5
Transferring Full Disclosure Files Through Wi-Fi
(Optional)
Before you begin, ensure the Wi-Fi card is properly seated with the name R Series
Data COMM or Data COMM II facing up in the compact flash slot. Make sure that the Wi-Fi
guard has been attached.
To transfer data through Wi-Fi:
1. Turn the Mode Selector to MONITOR.
2. Press the Report Data softkey.
3. Press the Transfer Mode softkey.
4. Press the Report to Wi-Fi softkey.
5. The Enter Report ID screen will appear, and you will be prompted to enter a unique report
ID. Use the arrow keys to select the desired characters, then press the Enter Char softkey.
Pressing the ... key will change the table to a different set of characters, including upper case
letters. To cancel and return to the previous screen, use the arrow keys and select Cancel.
Note: Enable Report ID must be enabled in System Configuration mode for the report screen
to appear (See the R Series Configuration Guide). If Enable Report ID is set to No,
then the screen will not be displayed and the report will be sent immediately.
6. To send the report, press the Send Report softkey. The R Series is now in Wi-Fi Transfer
Mode and a status text message box appears in the middle of the screen and describes the
status of the file being sent. When the full disclosure file is transferred, the messages
TRANSFER COMPLETE and Full Disclosure Was Sent are displayed.
7. To erase the report, press the Erase Report softkey. To keep the report and return to the
Transfer Mode screen, press the Return softkey.
Enter Report ID
m
y
n
z
o
0
;
p
1
,
q
2
@
r
:
3
.
s
4
+
t
5
_
u
... 6
v
7 8
w x
9
' " - ?
b c d e f g h i j k l Cancel
Del
Pat230
Enter
Char
Send
Report
a
DATA TRANSFER MODE
TRANSFER COMPLETE
Erase
Report
DATA TRANSFER MODE
Return
Full Disclosure Was Sent