ZOLL R Series Monitor Defibrillator Rev J - Manual (Page 491)

Manual Defibrillator Testing
9650-0912-01 Rev. K ZOLL R Series Operator’s Guide 12–9
Do not immerse any part of the defibrillator (or its accessories) in water. Do not use ketones
(such as acetone or MEK) on the defibrillator. Do not sterilize the defibrillator. Avoid using
abrasives (including paper towels) on the display window.
Take special care to clean the defibrillation paddles after each use. The buildup of gel can
interfere with ECG monitoring through the paddles, can adversely effect energy delivery and
may reduce operator safety. Keep the paddle handles clean as well.
Loading Stripchart Paper
The unit displays the message CHECK RECORDER when the printer is activated without paper
or if the supply runs out during printing.
Use ZOLL stripchart paper (Part number 8000-0300).
To load paper into the stripchart printer:
1. Press the release button and allow the printer door to open, then remove any paper.
Figure 12-5. Opening the Printer Door
2. Refer to the illustration inside of the paper compartment for proper paper orientation, and
place a new pad of stripchart paper in the tray.
Note: Paper feeds from the top of the stack with gridlines facing down.
3. Pull enough paper off the pad so that paper extends out of the unit when the printer cover is
closed.
4. Close the printer cover by pressing down lightly on the edge of the cover next to the release
button. Be sure the cover is flush with the top of the device.
?
3P/ 3P /