ZOLL R Series Monitor Defibrillator Rev J - Manual (Page 41)

R Series Service Manual
9650-0903-01 Rev. J 1- 31
18.0 SpO
2
Monitor Test (for SpO
2
Option)
Tools Needed:
• Masimo

Reusable Sensor.
• Masimo

Patient Cable.
• Fluke Biomedical Index 2PFE SpO
2
Simulator (or equivalent).
Test Setup:
1. Connect the OneStep cable to the test port.
2. DO NOT connect the ECG cable to the simulator.
3. Install the Masimo

Patient Cable and attach the Masimo

sensor to the patient cable.
4. Connect the Masimo

sensor to the finger simulation post.
5. Place a fully charged battery into the battery well or connect to AC power.
6. Ensure that the SpO
2
Simulator is off.
Do this... Observe this... Pass/Fail
18.1 Turn the selector switch to MONITOR(for AED
units turn to ON, and select MANUAL MODE.) The SpO
2
saturation percentage appears as a dashed line on the monitor. o o
18.2 Wait ten seconds.
Turn on the SpO
2
simulator. Press the SIM
softkey on the Index SpO
2
Simulator. Press the
MAN softkey.
The SpO
2
PULSE SEARCH message displays. o o
18.3 Press the 02+ or 02- softkey of the simulator
until the SpO
2
output is at 98%.
The R Series SpO
2
reading of 98 +/- 1% appears on the R Series monitor.
Note that you may need to wait up to 2 minutes for the information to appear on
the ZOLL display.
o o
18.4 Using the Index SpO
2
Simulator, press the
BPM+ or BPM- softkey until the heart rate is
230 BPM.
The SpO
2
rate 230 BPM displays on the simulator screen.
Note that you may need to wait up to 2 minutes for the information to appear on
the ZOLL display.
The SpO
2
saturation of 96-100% appears on the R Series display.
The heart rate of 226-234 BPM displays on the R Series monitor.
o o