ZOLL R Series Monitor Defibrillator Rev J - Manual (Page 478)

C HAPTER 11 F ILE T RANSFER
11–6 www.zoll.com 9650-0912-01 Rev. K
Note: If you are out of the range of an access point, the data will not be transferred and the
message Wi-Fi Network Not Found is displayed. Press the Return softkey to return to
the previous menu and try again.
To exit Wi-Fi/DataTransfer Mode, press the Return softkey and then the Exit Transfer
softkey or switch the Mode Selector to OFF.
Transferring Device Check and Activity Log Files
Through Wi-Fi (Optional)
Before you begin, ensure the Wi-Fi card is properly seated with the name R Series
Data COMM or Data COMM II facing up in the compact flash slot. Make sure that the Wi-Fi
guard has been attached.
To transfer data through Wi-Fi:
1. Turn the Mode Selector to MONITOR.
2. Press the Report Data softkey.
3. Press the Transfer Mode softkey.
4. Press the More softkey.
5. Press the Defib History to Wi-Fi softkey.
The R Series is now in Wi-Fi Transfer Mode and a status text message box appears in the
middle of the screen and describes the status of the files being sent. When the files are
transferred, the messages TRANSFER COMPLETE, Device Check Was Sent, and Activity
Log Was Sent are displayed.
Note: If you are out of the range of an access point, the data will not be transferred and the
message Wi-Fi Network Not Found is displayed.
To exit Wi-Fi/DataTransfer Mode, press the Return softkey and then the Exit Transfer
softkey or switch the Mode Selector to OFF.
TRANSFER FAILED
DATA TRANSFER MODE
Return
Full Disclosure Not Sent