Rockwell Automation 5720 DriveLogix System - Manual (Page 105)

1 Publication 20D-UM002C-EN-P - November 2003
Chapter
5
Configuring DriveLogix Motion
Using This Chapter
This chapter introduces DriveLogix motion. The steps in this chapter provide
the minimum settings required to begin testing of DriveLogix motion.
System Requirements
• PowerFlex 700S Drive with firmware revision 2.03 or higher
• DriveLogix controller with firmware revision 12.XX or higher
• DriveExecutive programming software version 2.02 or higher
• RSLogix 5000 programming software version 12 or higher
For information about: See page
Configuring the Drive 5-1
Programming the Controller 5-5
Supported Motion Commands 5-12