Rockwell Automation 5720 DriveLogix System - Manual (Page 233)

Publication 20D-UM002C-EN-P - November 2003
DriveLogix Back-Up on DeviceNet 12-9
Figure 11.5 shows rungs 3 & 4 and the message set-up used on it. The message
in rung 3 uses the INT data type.
Figure 11.5
This completes the required portion of ladder logic to enable the DriveLogix
back-up on DeviceNet. The following sections describe how to use additional
ladder logic to read back-up state and status. However, these sections are not
required to complete the back-up solution.
Rung 3 message configuration and communication tabs