Rockwell Automation 5720 DriveLogix System - Manual (Page 243)

Publication 20D-UM002C-EN-P - November 2003
DriveLogix System Specifications A-5
Are you using an
isolator? Use this cable:
No The 1756-CP3 cable attaches the controller directly to the
controller.
If you make your own cable, it must be shielded and the shields
must be tied to the metal shell (that surrounds the pins) on both
ends of the cable.
You can also use a 1747-CP3 cable (from the SLC product family).
This cable has a taller right-angle connector housing than the
1756-CP3 cable.
Yes The 1761-CBL-AP00 cable (right-angle connector to controller) or
the 1761-CBL-PM02 cable (straight connector to the controller)
attaches the controller to port 2 on the 1761-NET-AIC isolator.
The mini-DIN connector is not commercially available, so you
cannot make this cable.
2 RDX
3 TXD
4 DTR
COMMON
6 DSR
7 RTS
8 CTS
9
1 CD
2 RDX
3 TXD
4 DTR
COMMON
6 DSR
7 RTS
8 CTS
9
1 CD
2
3
4
5
6 7 8
6
7
8
9
1
2
3
4
5 1
DB-9 right-angle or straight
cable end
8-pin, mini-DIN cable end
Pin: DB-9 end: Mini-DIN end:
1 DCD DCD
2 RxD RxD
3 TxD TxD
4 DTR DTR
5 ground ground
6 DSR DSR
7 RTS RTS
8 CTS CTS
9 N/A N/A