Rockwell Automation 5720 DriveLogix System - Manual (Page 15)

Publication 20D-UM002C-EN-P - November 2003
Getting Started 1-3
Creating and Downloading
a Project The following diagram illustrates the steps you follow to create and download
a project. The remainder of this chapter provides examples of each step.
Create a project
go to page 1-4
1
Create tags
4
Enter logic
5
View status
7
Download
a project
6
You need:
• RSLogix 5000 programming software
• RSLinx communication software
• DF1 point-to-point, serial connection from the workstation
to the controller (using 1756-CP3 or 1747-CP3 cable)
If you don’t have this hardware, you can still follow these steps.
Substitute the I/O modules you have for the ones listed here and
make the appropriate changes.
System setup for this quick start:
Local
slot 0 1794-IB16
Configure
I/O modules
3
Configure
PowerFlex 700S Drive
2