Rockwell Automation 2711E-xxxx PanelView Operator Terminals User Manual - Manual (Page 101)

5–26 Configuring PanelView Operator Terminals
Publication 2711E-821 – January 1998
3. To set an operator’s code, enter a numeric sequence up to five
characters long. On a touch screen terminal, use the keypad on
the screen. On a keypad terminal, use the numeric keypad. Press
Enter to set the code.
4. Assign all the required operator codes.
5. Press OK when you are finished to save this information.
Screen Security
Screen security, even if configured in PanelBuilder, is not in effect
until the Screen Security setting is enabled at the terminal. Once
enabled, operators can access a restricted screen only by entering the
correct access code. If the code is invalid, the requested screen won’t
be displayed.
Press the Global tab in the Security window to display the following
screen.
This lets you enable or disable screen security for the application you
are running.
•
Enable
ĊIf you enable screen security, only authorized operators
will have access to screens with screen security assigned.
•
Disable
ĊIf you disable screen security, all operators will have
access to all screens, whether or not the screens have security
assigned to them. The Disable setting is the default.