Rockwell Automation 2711E-xxxx PanelView Operator Terminals User Manual - Manual (Page 107)

5–32 Configuring PanelView Operator Terminals
Publication 2711E-821 – January 1998
For enhanced PanelView 1200 (Series F and above), and PanelView
1200e and 1400e terminals, the following screen is displayed.
Button Audio, Alarm Audio, Audio Volume
The terminal can sound a beep whenever you press an active touch
cell or function key. The PLC controller can also trigger this audio
indicator either directly with the PLC Controlled Audio, or through
an alarm message.
To change audio settings:
1. Disable Button Audio or Alarm Audio, or to change the Audio
Volume, press the corresponding button or function key.
2. Press OK to save your settings.
•
Button Audio
ĊThe default setting is On. The terminal beeps
each time you press a button.
•
Alarm Audio
ĊThe default setting is On. Both the PLC
Controlled Audio bit and alarm triggered audio can cause the
terminal’s built-in audio indicator to beep. Changing this to Off
will disable both the alarm triggered audio and PLC Controlled
Audio operation (see your PanelBuilder 1400e Configuration
Software for Windows User Manual for details).
•
Audio Volume
ĊThe default setting is High. You can change this
to Low.