Rockwell Automation 2711E-xxxx PanelView Operator Terminals User Manual - Manual (Page 47)

Chapter
3
Publication 2711E-821 – January 1998
Installing PanelView 1200e
Terminals
This chapter explains how to install a PanelView 1200e terminal in
your plant. Specifically, it provides:
•
terminal dimensions
•
a list of tools for installing the terminal
•
cutout dimensions for panel mounting
•
information about mounting options
This chapter also provides information about the correct use of the
following hardware features, specifically:
•
how to adjust contrast and brightness
•
how to switch modes
•
how to connect power to the terminal
•
how to connect a serial printer
•
how to connect an external alarm relay
•
how to connect a terminal to your PLC system
•
information about PCMCIA cards
Refer to Chapter 1 for information about the Upload/Download cable
and remote keyswitch assembly.
Figure 3.1 shows the rear panel of the PanelView 1200e terminal.
Note the location of the power connector, alarm relay connector,
RS-232 port, and Remote I/O and DH+ connector.
Overview