Rockwell Automation 2711E-xxxx PanelView Operator Terminals User Manual User Manual

Page 45

Advertising
background image

2–14

Installing PanelView 1000e Terminals

Publication 2711E-821 – January 1998

To connect the PanelView 1000e terminal to the DH+

network:

1. Remove the Remote I/O and DH+ connector plug from the rear of

the terminal.

2. Back out plug terminal screws 2 and 1 on the connector. See

Figure 2.14 for plug connection locations.

3. Connect the blue wire to plug terminal 1 and the clear wire to

plug terminal 2. Connect shield and shield drain wire to middle
plug terminal. Tighten the screws to secure the wires.

4. Re-insert the plug into the terminal connector.

Note: If the terminal is the last device on the link, connect a 1/2 watt
terminating resistor across terminals 1 and 2. The value of the
resistor depends on the DH+ baud rate:

for 57.6 kilobaud and 115.2 kilobaud, use a 150-ohm resistor
(A-B Part Number 740018-29)

for 230 kilobaud, use an 82-ohm resistor (A-B Part Number
740018-23)

To connect the PanelView 1000e terminal to the ControlNet network:

The PanelView 1000e terminal (A-B Catalog Number 2711E-T10C6
and 2711E-K10C6) requires an enhancement with a 1784-KTCX or
1784-KTCX15 card and 2711E-NA2 adapter. You can use the
ControlNet-enhanced PanelView 1000e terminals (A-B Catalog
Number 2711E-T10C7, 2711E-T10C15, 2711E-K10C7, and
2711E-K10C15).

"

Connect a PanelView Terminal to a ControlNet network via a tap
with a 1-meter (39.4-inch) drop cable. Use any tap with one of
the following catalog numbers: 1786-TPS, 1786-TPYS,
1786-TPR, or 1786-TPYR. See the ControlNet PLC-5
Programmable Controllers User Manual
(A-B publication
1785-6.5.14) for more information about ControlNet taps.

Note: ControlNet taps contain passive electronics and must be
purchased from Allen-Bradley for the network to operate correctly.

Note: If the terminal is the last device on the link, connect a
75-ohm, 1-watt terminating resistor to the unused connector on the
tap (A-B Catalog Number 1786-XT).

See the ControlNet PLC-5 Programmable Controllers User Manual
(A-B publication 1785-6.5.14), the ControlNet Communication
Interface
Card (A-B publication 1784-5.20), and the ControlNet
Planning and
Installation Manual (A-B publication 1786-6.2.1) for
more information about ControlNet.

"

"

"

Advertising