Rockwell Automation 2711E-xxxx PanelView Operator Terminals User Manual - Manual (Page 123)

5–48 Configuring PanelView Operator Terminals
Publication 2711E-821 – January 1998
To open the Upgrade Firmware screen, press the Upgrade Firmware
button on the Terminal Configuration screen.
For PanelView keypad terminals, the following Upgrade Firmware
screen is shown.
For PanelView touch screen terminals, the following Upgrade
Firmware screen is shown.
" Initiate Serial Transfer
ĊA serial firmware upgrade is initiated
at the development computer using the serial transfer utility
provided. (For details on how to install the Serial Firmware
Upgrade Utility, see Appendix D.) The serial port is set
automatically so you don’t need to configure it.
Upgrading Firmware