Rockwell Automation 2711E-xxxx PanelView Operator Terminals User Manual - Manual (Page 122)

5–47 Configuring PanelView Operator Terminals
Publication 2711E-821 – January 1998
For PanelView touch screen terminals, the following Restore
Defaults screen is shown.
To cause the selected application to write out its initial values:
" Press the Load Application Initial Values button. This allows the
selected application to write out its initial values on the next entry
to Run mode.
Note: This button is disabled if a current application has not been
specified.
To restore the terminal configuration defaults:
" Press the Load Terminal Configuration Defaults button.
The default values are restored for the following screens:
•
Transfer Setup
•
Application Startup
•
Security
•
Time and Date
•
Terminal Response
•
Printer
•
Align Screen
Note: If an application is currently selected, the network
communication Baud Rate and terminal network address will be
retrieved from the application file and stored in the terminal’s
parameters.
"
"