Rockwell Automation 2711E-xxxx PanelView Operator Terminals User Manual - Manual (Page 91)

5–16 Configuring PanelView Operator Terminals
Publication 2711E-821 – January 1998
Processor Baud Rates Valid PLC Racks Revision Series
PLC-5/60C
PLC-5/60C 1.5 All All 1–27 octal 57.6 kbps
115.2 kbps
230.4 kbps
PLC-5/80 All All 1–27 octal 57.6 kbps
115.2 kbps
230.4 kbps
PLC-5/80C
PLC-5/80C 1.5 All All 1–27 octal 57.6 kbps
115.2 kbps
230.4 kbps
PLC-5/80E All All 1–27 octal 57.6 kbps
115.2 kbps
230.4 kbps
PLC-5/250 All All 1–37 octal 57.6 kbps
115.2 kbps
230.4 kbps
DH+ Direct/ControlNet Direct
You can upload and download application files over a direct DH+ or
ControlNet link. File transfers over DH+ or ControlNet are initiated
by PanelBuilder or File Utility Transfer and are available in Run
mode only. You must specify the DH+ or ControlNet communication
parameters and terminal’s network address in PanelBuilder — your
terminal will accept those parameters by default. For DH+, you can
change the Baud and Terminal Network Address at the terminal
using the Transfer Setup screen and Terminal Network Setup screen.
Setting Address Source
To do a DH+ Direct or ControlNet Direct transfer, you must choose
either Application or Network Direct as the Address Source. The
first time you enter this screen, the default is Application. When you
re-enter the screen, the values that were previously saved, appear.
•
Application — When you choose Application, all the
configuration parameters are taken from the currently-selected
application file. This is the default setting.
•
Network Direct —When you choose Network Direct, the
configuration parameters for the application file are disabled.
Important: After a successful download of an application file over
DH+ or ControlNet, the terminal automatically resets
the Address Source to Application, uses the application
file parameters, and discards the Manual Address
parameters.