Rockwell Automation 2711E-xxxx PanelView Operator Terminals User Manual User Manual
Page 104
5–29
Configuring PanelView Operator Terminals
Publication 2711E-821 – January 1998
For PanelView touch screen terminals, the following Time and Date
screen is shown.
You can customize the time display using the Format, Show
Seconds, and Leading Digit buttons. The previous screen’s sample
display shows the time in 12-hour format, with seconds showing, and
with a leading zero before the hour.
To set the time:
1. Make sure the Time screen is open.
2. Make your selections for Format, Show Seconds, and Leading
Digit, shown on the left of the window. The defaults are 12-hour
Format, Yes for Show Seconds, and Zero for Leading Digit.
3. Use the Up and Down arrows to select hours, minutes, and
seconds. You must enter the time in 24-hour format.
4. Press OK to set the terminal’s time.
The time will ‘tick over’ as you set it, but the terminal’s clock is
not set until you press OK.