Rockwell Automation 2711E-xxxx PanelView Operator Terminals User Manual - Manual (Page 88)

5–13 Configuring PanelView Operator Terminals
Publication 2711E-821 – January 1998
Pass-Through Application File Transfers
Pass-Through file transfers are initiated by PanelBuilder and are only
available when the terminal is in Run mode, over the following
networks:
•
DH+ and Remote I/O networks, using the PLC-5 or SLC-5/04
controller’s Pass-Through feature
•
ControlNet and Remote I/O networks using the PLC-5C
controller’s Pass-Through feature
•
Ethernet and Remote I/O networks using the PLC-5E controller’s
Pass-Through feature
The file transfer can proceed using the Pass-Through parameters of
the terminal’s current application. If there is no current application or
Pass-Through parameters, or you don’t want to use the application’s
parameters, you can change the Pass-Through parameters in File
Transfer Utility and PanelView. Both the File Transfer Utility and
PanelView Pass-Through parameters must match.
To set up for Pass-Through file transfer, select the Network tab in the
Transfer Setup screen.
Selecting Auto Restart
You can choose between Yes and No for the Auto Restart option.
The default setting is No.
•
If you choose Yes, the terminal starts executing the current
application file when the application download completes
successfully. If the downloaded application is made current, it
executes; otherwise the previously running application executes.
•
If you choose No, you must press the Resume Run mode button
in the Application Transfer screen.