Rockwell Automation 2711E-xxxx PanelView Operator Terminals User Manual - Manual (Page 146)

Specifications: 1000e Operator Terminal A–3
Publication 2711E-821 – January 1998
Careful wire routing helps cut down on electrical noise. To reduce
electrical noise, the PanelView 1000e Operator Terminal should be
connected to its own branch circuit.
!
ATTENTION: The input power source should be
protected by a fuse or circuit breaker rated at no more
than 15 amps.
Route incoming power to the PanelView 1000e terminal by a
separate path from the communication cable.
!
ATTENTION: Do not run signal wiring and power
wiring in the same conduit.
Where power and communication lines must cross, they should do so
at right angles. Communication lines can be installed in the same
conduit as low-level, dc I/O lines (less than 10 volts).
•
Keypad terminal 11.6 lbs (5.3 kg)
•
Touch screen terminal 11.3 lbs (5.1 kg)
These weights do not include any shipping materials used to package
the terminal.
This section describes front panel design specifications for the
PanelView 1000e keypad and touch screen terminals.
Keypad Terminals
Key Panel: sealed, stainless steel dome membrane switches with
tactile feedback and an actuation force of 1 lb.
(0.455 kg), mounted on the key panel’s reinforced
plastic bezel, protected with a hard-coated,
scratch-resistant polyester surface. Keys are rated for
2,000,000 presses.
Window: clear, hard-coated, scratch-resistant polyester
over chemically strengthened glass
Custom legends can be inserted in the 21 user-configurable function
keys.
Wiring Recommendations
Terminal Weights
Front Panel Design