Rockwell Automation 2711E-xxxx PanelView Operator Terminals User Manual - Manual (Page 29)

1–16 Introducing the PanelView Terminals
Publication 2711E-821 – January 1998
6008-SQ DEC Q-BUS I/O Scanner
This module can be installed into a DEC Q-Bus controller to provide
it with an Allen-Bradley 1771 Remote I/O Link. Allen-Bradley
Remote I/O racks and devices such as the PanelView
1000e/1200e/1400e terminal can then be connected to this controller.
DH+ Communications
The terminal can be directly connected to a DH+ network so it can
communicate with several controllers simultaneously. It can be
connected to the SLC-5/04 and the following PLC-5 host controllers
over DH+.
PLC-5/10, 5/11, 5/15, 5/20, 5/25, 5/30, 5/40, 5/60, 5/80, 5/40L,
5/60L, 5/80L
One or more terminals can be connected directly to one of the PLC-5
family of programmable controllers over DH+ so it can
communicate with several controllers simultaneously.
SLC-5/04
One or more terminals can be connected directly to one of the
SLC-5/04 family of programmable controllers over DH+ so it can
communicate with several controllers simultaneously.
PLC2/PLC3
The terminal supports communications to one or more PLC2s or
PLC3s via offlink addressing: the PLC2 also communicates by a
1785-KA module (DH+ to DH bridge), while PLC3 communication
is by a 1775-KA module.
ControlNet Communications
To communicate on ControlNet, install the ControlNet
Communication Interface Card (A-B Catalog Number 1784-KTCX,
Series B or later) in your PanelView terminal. This card enables the
terminal to communicate with devices on the ControlNet network
and also acts as an interface between the terminal and ControlNet for
ControlNet-Direct application file transfers. The 1784-KTCX card is
pre-installed in PanelView 1000e and 1400e operator terminals (A-B
Catalog Numbers 2711E-K10C7, 2711E-T10C7, 2711E-K14C7, and
2711E-T14C7).