Rockwell Automation 2711E-xxxx PanelView Operator Terminals User Manual User Manual
Page 39
2–8
Installing PanelView 1000e Terminals
Publication 2711E-821 – January 1998
Figure 2.8 Keypad Terminal Clip Mount (Side View)
24772
Gasket
Front Bezel
Rack Mount Adapter
or User Panel
Screw Driver Slot
Mounting
Clip
Mounting Slot
Upper Right Side
Touch Screen
Terminal Front Bezel
Figure 2.9 Keypad Terminal Clip Mount (Back View)
24780
Foot Pad
Mounting Slot
Mounting Clip
Panel Mount Screw
Screw Driver Slot
3. Tighten the mounting clip screws to a torque of 10 inch-pounds.
Do not over-tighten.
!
ATTENTION: Tighten mounting clips to a torque of
10 inch-pounds to provide a proper seal and to prevent
potential damage to the terminal. Allen-Bradley
assumes no responsibility for water or chemical
damage to the terminal or other equipment within the
enclosure because of improper installation.