Rockwell Automation 2711E-xxxx PanelView Operator Terminals User Manual - Manual (Page 83)

5–8 Configuring PanelView Operator Terminals
Publication 2711E-821 – January 1998
For PanelView touch screen terminals, the following Transfer
Application screen is shown.
2. Initiate the file upload or download from the development
computer, using PanelBuilder or File Transfer Utility, from the
Upload or Download dialog box. You must have the Transfer
Application screen displayed on the terminal.
Note: File transfers are initiated and controlled by the PanelView
1200/1400e Transfer Utility. You can, however, cancel a file transfer
at the terminal by switching the terminal to Run mode or by cycling
power.
Once the upload or download has been initiated, a screen is
displayed that includes a meter to inform you of upload, download,
or format progress. A message indicates when the upload or
download is complete.
If you are downloading to a data partition on a PCMCIA card or the
onboard application memory, and that data partition is full, you can
request the destination be formatted from the PanelBuilder computer.
You cannot stop a format operation. The Exit button is disabled.
"