Rockwell Automation 2711E-xxxx PanelView Operator Terminals User Manual - Manual (Page 177)

Installing the PanelView Serial Firmware Upgrade Utility D–6
Publication 2711E-821 – January 1998
7. Follow the setup instructions as they appear on your screen.
To complete the setup, enter any required information and insert
the second disk when prompted.
Do not cancel the installation while it is in progress. If you want
to cancel the installation, let the installation finish, then use the
Uninstall Serial Firmware Upgrade Utility to remove all the
installed files.
8. When the installation is complete, remove the installation diskette
from the drive.
The PanelView Serial Firmware Upgrade Utility supports additional
communication drivers besides the three core drivers—Remote I/O,
DH+, and ControlNet. If an additional driver is supported, a diskette
that contains an install and uninstall program is supplied in the kit for
that network driver.
To install an additional driver:
1. Close the PanelView Serial Firmware Upgrade Utility before you
install the driver.
2. Insert the diskette in the floppy drive.
3. If you are installing on Windows NT or Windows 95, press the
Start button and choose Run.
If you are installing on Windows 3.x, choose Run from the File
menu of Program Manager or File Manager.
4. In the Run window, type:
a:setup or b:setup
5. Follow the installation instructions as they appear on your screen.
When the registration window appears, you must enter
registration information that is provided in the kit for the network
driver.
6. When the installation is complete, remove the diskette from the
floppy drive.
7. Start the PanelView Serial Firmware Upgrade Utility. The new
driver is displayed on the list of available drivers.
Installing Additional
Communication Drivers