Rockwell Automation 2711E-xxxx PanelView Operator Terminals User Manual - Manual (Page 173)

Installing the PanelView Serial Firmware Upgrade Utility D–2
Publication 2711E-821 – January 1998
11. Choose the program folder (program group) in which you want to
install the SFU32’s icons, which includes a Readme file icon, the
Upgrade Utility icon, and an Uninstall icon. By default, the icons
are installed in the PanelBuilder 1400e program folder. Then
choose Next.
12. The setup utility shows a summary of the choices you made in the
preceding dialog boxes. To make any changes, choose the Back
button. Otherwise, choose Next to begin the installation.
Do not cancel the installation while it is in progress. If you want to
undo the installation, let the installation finish, then use the Uninstall
Serial Firmware Upgrade Utility to remove all the installed files and
to update the registration.
The Serial Firmware Upgrade Utility Version 3 (SFU) software is
provided on CD-ROM. The software installation program creates a
directory on your hard drive for the PanelView Serial Firmware
Upgrade Utility and copies all necessary files to it. By default, the
drive and directory is C:\AB\PB1400e\SFU. You can change this
default.
To install SFU:
1. Start Windows 95 or 3.x. If you’re already in Windows, close all
open Windows applications.
2. Insert the CD-ROM in the drive.
The CD-ROM begins to run automatically.
3. If you are running on Windows 95, choose Run from the Start
button, or select setup.exe from Windows Explorer.
If you are running on Windows 3.x, choose Run from the File
menu. In the Run windows, type:
d:setup
where d is the drive containing the PanelView Serial Firmware
Upgrade Utility CD-ROM, and press Enter.
4. In the Welcome dialog box, choose Next.
Installing SFU from
CD-ROM on Windows 95
or Windows 3.x