Rockwell Automation 2711E-xxxx PanelView Operator Terminals User Manual - Manual (Page 32)

Chapter
2
Publication 2711E-821 – January 1998
Installing PanelView 1000e
Terminals
This chapter explains how to install a PanelView 1000e terminal in
your plant. Specifically, it provides:
•
terminal dimensions
•
a list of tools for installing the terminal
•
cutout dimensions for panel mounting
•
information about mounting options
This chapter also provides information about the correct use of the
following hardware features, specifically:
•
how to switch modes
•
how to connect power to the terminal
•
how to connect a serial printer
•
how to connect an external alarm relay
•
how to connect a terminal to your PLC system
•
information about the Upload/Download cables and PCMCIA
cards
Figure 2.1 shows the rear and bottom panel of the PanelView 1000e
terminal. Note the location of the power connector, alarm relay
connector, RS-232 port, and Remote I/O and DH+ connector.
Figure 2.1 Rear and Bottom View of PanelView 1000e
Terminal
Run/Configuration Switch
1
2
ISA Card Slots
1
2 PCMCIA Memory
Card Slots (Slot 1
is active; slot 2 is
inactive and has a
protective label
cover.)
Remote I/O DH+ Connector
Alarm Relay Connector
Power Connector
RS-232 Port
24771
Overview