Rockwell Automation 2711E-xxxx PanelView Operator Terminals User Manual - Manual (Page 40)

2–9 Installing PanelView 1000e Terminals
Publication 2711E-821 – January 1998
4. Remove the protective installation label covering the top vents of
the terminal.
!
ATTENTION: Remove the protective installation
label covering the top vents to prevent overheating and
damage to the terminal.
Mounting a Touch Screen Terminal in a 19-inch Rack
To mount the PanelView 1000e Clip-Mount Touch Screen terminals
in a standard 19-inch EIA rack, you need a Rack Mount Kit (A-B
Catalog Number 2711-NR6T). This kit consists of a rack adapter and
mounting hardware.
Mounting a Keypad Terminal in a 19-inch Rack
To mount the PanelView 1000e Clip-Mount Keypad terminals in a
standard 19-inch EIA rack, you need a Rack Mount Kit (A-B
Catalog Number 2711-NR6K). This kit consists of a rack adapter and
mounting hardware.
You have several options for setting up the terminal. Figure 2.1
shows the locations of the options described in the remainder of this
chapter.
Switching Modes
The terminal operates in Configure and Run modes. Configure mode
lets you set up the terminal and Run mode executes the application
file. To switch between modes, you can use either of the following
methods:
•
the hardware Mode Select Keyswitch, located at the back of the
terminal
•
the Software Mode Switch (available in PanelView firmware
version 3 and above) that you can set to Enable or Disable from
the Terminal Configuration screen. For details, see Mode Switch
in Chapter 5 of this manual.
Note: The terminal communicates with your PLC only when the
terminal is in Run mode, so set it to this mode to monitor and control
your PLC application.
Setting Up the PanelView
1000e Terminal
"