Rockwell Automation 2711E-xxxx PanelView Operator Terminals User Manual - Manual (Page 163)

Specifications: 1400e Operator Terminal C–2
Publication 2711E-821 – January 1998
If the PanelView 1400e Operator Terminals are installed within the
European Union or EFTA regions, the following regulations apply.
EMC Directive
This product is tested to meet Council Directive 89/336/EEC
Electromagnetic Compatibility (EMC), using the following standards
in whole or in part.
•
EN 50081-2:1993 (EMC Generic Emission Standard
Part 2–Industrial Environment)
•
EN 50082-2:1995 (EMC Generic Immunity Standard
Part 2–Industrial Environment)
Low Voltage Directive
This product is tested to meet Council Directive 73/23/EEC with
amendments, including 93/68/EEC Low Voltage (LVD), using the
pertinent sections of the following standards.
•
EN61010-1:1995 (Safety Requirements for Electrical Equipment
for Measurement, Control, and Laboratory Use)
Intended Use of Product
According to these Standards, the factor that determines, for EMC
purposes, whether an apparatus is deemed to be “industrial” or
“Residential, commercial and light industrial,” is given in Clause 1
of EN50081-2 as follows:
Apparatus covered by this standard is not intended for connection to
a public mains network but is intended to be connected to a power
network supplied from a high- or medium-voltage transformer
dedicated for the supply of an installation feeding a manufacturing or
similar plant.
PanelView 1400e Operator terminals are intended for use solely in
an industrial environment as defined above. When installed in
Europe, any other application is in contravention of European Union
Directives, and a breach of these laws.
European Union Directive
Compliance