Rockwell Automation 2711E-xxxx PanelView Operator Terminals User Manual - Manual (Page 111)

5–36 Configuring PanelView Operator Terminals
Publication 2711E-821 – January 1998
To set the Stuck Cell timeout:
" Use the Up and Down arrows to set the amount of time from 0 to
60 seconds. A setting of 0 disables the function. The default
setting is 0.
Screen Saver Display Intensity (1000e only)
The Screen Saver tab allows you to set the intensity level for the
screen saver display. The backlight can be dimmed or switched off.
Frequent switching off can shorten the life of the backlight. (For
information on backlight replacement, see Chapter 7, Maintaining
PanelView Terminals.) When the backlight is dimmed, you can still
see the screen saver graphic.
To set the intensity level for the screen saver:
1. Press the Screen Saver tab in the Terminal Response screen.
The following screen is displayed.
2. Use the Backlight Intensity Level button to cycle through the
intensity levels. You can also use the button to switch off the
backlight. The default is set at the lowest intensity level, which is
50%. You can test the intensity level you have set by using the
Test Screen Saver button.
3. Set the Screen Saver Timeout. The default setting is 0, which
disables the screen saver. For details on the screen saver timeout
feature, see Screen Saver Timeout below.