Rockwell Automation 2711E-xxxx PanelView Operator Terminals User Manual - Manual (Page 82)

5–7 Configuring PanelView Operator Terminals
Publication 2711E-821 – January 1998
2. To change the settings, press the Baud Rate, Parity, or Error
buttons to move the check mark to the setting you want.
•
Baud Rate
ĊThe speed at which data is transmitted over the
serial cable. The default setting for a serial transfer is 9600
baud.
•
Parity
ĊUsed for checking data transferred between the
development computer and terminal. The default setting is
None.
•
Error
ĊUsed to check for errors in data transmission and is
either
– CRC
Ċcyclical (or cyclic) redundancy check.
– BCC
Ċblock check character. BCC is the default setting.
3. When you have selected the required settings, press OK to exit
this screen.
For detailed instructions on configuring the computer’s serial port,
see the PanelView 1200/1400e Transfer Utility User Manual.
To transfer an application serially:
1. Press the Transfer Application button on the Terminal
Configuration screen to display the Transfer Application screen.
For PanelView keypad terminals, the following Transfer
Application screen is shown.