Metrohm tiamo 2.2 Manual - Manual (Page 1169)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.2 ￭￭￭￭￭￭￭￭ 1155
5.6.8.4 REPORT
5.6.8.4.1 REPORT - Overview
Dialog window: Method ▶ REPORT ▶ Properties... ▶ REPORT - 'Command name'
Command for the output of determination data.
Appearance
The command has the following appearance:
Parameters
The parameters for the command REPORT are configured in the following
dialog window:
￭ REPORT - Properties
Note
A REPORT command must always be placed before a DATABASE com-
mand, because otherwise the command data (e.g., the report template
used) will not be stored and no reprocessing will be possible.
Command variables
The following command variables are generated in the method run by the
command REPORT and can be used in formulas under the designation
'Command name.Variable designation':
Identifi-
cation Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
not ever been started
.FIN Command status; 1 = Command has been ended at
least once, 0, invalid (variable not available) = Com-
mand has never been ended