Metrohm tiamo 2.2 Manual - Manual (Page 25)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 1 Introduction
tiamo 2.2 ￭￭￭￭￭￭￭￭ 11
Program part Configuration
￭ Global variables, text templates and sample assignment tables can be
exported and imported.
￭ When changing the titer, the values Date titer det., Titration
method, User are additionally saved in the Audit Trail.
Program part Manual Control
￭ If all stirrers are selected, no Stirring time for continuous operation can
be entered.
1.10.3 Fixed bugs and problems
General
￭ When tiamo is closed before the login dialog appears, then an exception
may occur.
￭ If having canceled after the entry of the licence update (tiamo 1.x to tiamo
2.x) and tiamo is normally started afterwards, an error message occurs.
Program part Workplace
￭ Fast reading-in of barcodes can lead to the fact, that no more barcodes
can be read-in.
￭ If a titration command is started via a SEND command in status Cond
not ok, then no entry appears in the message list.
Program part Database
￭ The data of a conductivity determination is not displayed with the menu
item Determinations
▶ Show calibration curve....
￭ The blank value with a concentration calibration is not being recalculated
in the Recalculating.
￭ Indexed method variables get lost during the Recalculating.
￭ With fixed reports, in the selection list, the report Used titrants/solu-
tions is missing.
￭ The run test returns an exception when a WEIGH command is present
in the method.
Program part Method
￭ DOS: For Titrinos, the stirrer mistakenly occurs on the tab General/
Hardware.
￭ In the method parameters report the field Tolerance is missing for CAL
Spec.
Program part Configuration
￭ When newly adding a Titrando, the firmware version is not being
checked.
￭ The PREP warning does not appear for the 700 Dosino and 685 Dosimat.