Metrohm tiamo 2.2 Manual - Manual (Page 1439)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 7 Devices
tiamo 2.2 ￭￭￭￭￭￭￭￭ 1425
Number of positions
Shows the number of positions on the rack. If no rack is in position then the
display will be empty.
Shift rate
Sample rack speed of rotation for manual operation.
Range 3 ... 20 °/s
Default value 20 °/s
[Rack Data]
Opens the dialog window Rack data (see Chapter 6.11.3.1, page 1339) or
Rack data (774) (see Chapter 6.11.3.6, page 1344) in which the data of
the rack attached can be displayed and edited.
[Initialize rack]
Initializes the attached rack. This resets the rack, the lift and the robotic arm,
reads out the rack code and transfers the corresponding rack data to the
Sample Processor.
7.13.5 Properties - MSB #
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ MSB #
On the tabs MSB # the properties of the connector and the devices con-
nected to are displayed.
Request for dosing device preparation
Selection when the request for carrying out the command PREP (see Chap-
ter 5.6.6.5.1, page 1108) (prepare) is to be shown for the dosing device
connected to the MSB.
At program start
on | off (Default value: on)
If this option is switched on then at each program start the request to pre-
pare the dosing device will appear.
On attaching an exchange/dosing unit
on | off (Default value: on)
If this option is switched on then at each attaching of an exchange or dosing
unit the request to prepare the dosing device will appear.