Metrohm tiamo 2.2 Manual - Manual (Page 1203)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.2 ￭￭￭￭￭￭￭￭ 1189
5.6.10.4.2 LOOP - Properties
Dialog window: Method ▶ LOOP ▶ Properties... ▶ LOOP - Loop #
Command name
Name of the command.
Input 25 characters
Stop criteria
Definition of three possible stop criteria. The first stop criterion to be fulfilled
will stop the loop.
Maximum run number
on | off (Default value: on)
If this option is enabled, then the maximum number of runs will be used as
stop criterion by repeat and while loops. If the maximum number of runs is
reached, the loop will be canceled at the time the LOOP command is started
again.
Range 0 ... 999
Default value 1
Maximum run time
on | off (Default value: off)
If this option is enabled, then the maximum run time will be used as stop
criterion by repeat and while loops. The starting point for the run time is the
first start of the loop command, which means that the run time for While
loops is started only after the loop has been run through once. If the max-
imum run time is reached, the loop will be canceled at the time the LOOP
command is started again.
Range 0 ... 999.9
Selection min | s
Default value min
Note
The run time is paused if the method is stopped with [HOLD].
Condition
on | off (Default value: off)
If this option is enabled, then the condition defined here will be used as stop
criterion by repeat and while loops.