Metrohm tiamo 2.2 Manual - Manual (Page 189)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 3 Workplace
tiamo 2.2 ￭￭￭￭￭￭￭￭ 175
DOS
Selection
Measured value | Time | Temperature | Volume
| dV/dt | Calculated 1...3 | External 1...3 | off
TET
Selection
Measured value | Time | Volume | Calculated
1...3 | External 1...3 | off
Curve display
on | off (Default value: off)
If this option is enabled the curves required are displayed in the subwindow
Live display.
x axis
Selection of the quantity shown on the x axis.
DET
Selection
Volume | Measured value | Time | Temperature
| ERC | Calculated 1…3 | External 1…3
Default value Volume
MET
Selection
Volume | Measured value | Time | Temperature
| dMW | Calculated 1…3 | External 1…3
Default value Volume
SET
Selection
Time | Measured value | Temperature | Volume
| dV/dt | Calculated 1…3 | External 1…3
Default value Time
KFT
Selection
Time | Measured value | Temperature | Volume
| dV/dt | Calculated 1…3 | External 1…3
Default value Time
KFC / BRC
Selection
Time | Measured value | Quantity | drift |
Charge | dV/dt | Ugen | Igen | Calculated 1…3 |
External 1…3
Default value Time