Metrohm tiamo 2.2 Manual - Manual (Page 1321)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 6 Configuration
tiamo 2.2 ￭￭￭￭￭￭￭￭ 1307
Upper limit
Upper warning limit for the slope.
for pH electrode
Range
-2.147E+9 ... 2.147E+9 %
Default value 102.5 %
for ISE (+1)
Range
-2.147E+9 ... 2.147E+9 mV
Default value 61.2 mV
for ISE (-1)
Range
-2.147E+9 ... 2.147E+9 mV
Default value -57.2 mV
for ISE (+2)
Range
-2.147E+9 ... 2.147E+9 mV
Default value 31.7 mV
for ISE (-2)
Range
-2.147E+9 ... 2.147E+9 mV
Default value -27.7 mV
for ISE (+3)
Range
-2.147E+9 ... 2.147E+9 mV
Default value 21.7 mV
for ISE (-3)
Range
-2.147E+9 ... 2.147E+9 mV
Default value -17.7 mV
for ISE (+4)
Range
-2.147E+9 ... 2.147E+9 mV
Default value 16.8 mV
for ISE (-4)
Range
-2.147E+9 ... 2.147E+9 mV
Default value -12.8 mV
Intervention limits for slope (only for pH and ISE electrodes)
on | off (Default value: off)
If this option is enabled, then the values for the slope will be shown in
red if the limits are exceeded.