Metrohm tiamo 2.2 Manual - Manual (Page 162)

3.6 Subwindow Run ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
148 ￭￭￭￭￭￭￭￭ tiamo 2.2
5 - Method start
The following checks and actions are triggered with method start:
￭ Assign determination ID
A unique determination ID is assigned for the determination.
￭ Reserve devices (modules)
The devices and/or their function units used by the device-dependent
commands of the method are reserved for the duration of the determi-
nation, i.e. they can neither be used in other workplaces nor can they be
operated manually.
￭ Increase sample number
The Sample number is increased by +1.
￭ Increase statistics counter
If the statistics is activated in the START command as well as on the tab
Determination series the statistics counter is increased by +1. If a new
method has been loaded or if the statistics counter corresponds to the
setpoint counter, the current statistics data is deleted before and the
statistics counter is set to 0.
6 - Main run
The following actions may be carried out during processing of the method
loaded:
￭ Process series start track
At the beginning of the first determination of a series the Series start
track is started. If [Stop] is pressed during running this track, the Exit
track is started, if an error occurs, the Error track.
￭ Process the main track
After the start of the Main track the status switches to BUSY. The
commands of the main track and of the tracks requested by the latter
are processed in sequence. If tracks, which are not free, are requested
by the main track, waiting takes place until these tracks can be started.
￭ Stop run and continue
A running determination can be interrupted at any time with [Hold] and
continued with [Cont]. Thereby, all active tracks are interrupted and
continued jointly.
￭ Stop series and continue
A running series can be interrupted at any time with [Pause]. Thereby,
the ongoing determination of the sample series will still be carried out to
completion, but no new determination will be started. The next deter-
mination of the interrupted sample series is started with [Cont].
￭ Cancel run
A determination that is running can be interrupted at any time with
[Stop]. Afterwards the Exit track (if present) is run through and the
determination is stopped.