Metrohm tiamo 2.2 Manual - Manual (Page 577)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.2 ￭￭￭￭￭￭￭￭ 563
ascending
Only equivalence points with a positive slope of the titration curve will
be recognized.
descending
Only equivalence points with a negative slope of the titration curve will
be recognized.
off
Equivalence point recognition is switched off.
Evaluation with measured value window (pH)
[New]
Opens the dialog window Measured value # in which the parameters for
a new window can be entered (see Chapter 5.6.3.3.2.9, page 569).
[Properties]
Opens the dialog window Measured value # in which the parameters for
the selected window can be edited (see Chapter 5.6.3.3.2.9, page 569).
[Delete]
Deletes the window selected in the table.
Evaluation with volume window (mL)
[New]
Opens the dialog window Volume window # in which the parameters for
a new window can be entered (see Chapter 5.6.3.3.2.10, page 570).
[Properties]
Opens the dialog window Volume window # in which the parameters for
the selected window can be edited (see Chapter 5.6.3.3.2.10, page
570).
[Delete]
Deletes the window selected in the table.
5.6.3.3.2.7 MET pH - Additional evaluations
Tab: Method ▶ MET pH ▶ Properties... ▶ Additional evaluations
Command name
Name of the command.
Input 25 characters
The following additional methods for evaluation of titration curves can be
activated and defined on this tab: