Labconco PURICARE Procedure Station Models 31260 - Manual (Page 44)

Product Service 1-800-522-7658 44
The Logic+ has three circuit boards. The ECM microprocessor and power
supply board, located in the end of the ECM, the control board on the right
side wall, shown in Figure 2-5, and the power supply board assembly,
located in the electronics module, as shown in Figure 1-13.
Figure 1-13
UV Relay
Light Relay
Outlet Relay
The Logic+ also has an optional contact/RS232 board. This must be installed
if the user wants to signal external building monitors or controllers, or wants
the Logic+ to output operating information to a data logger. The optional
board is located in the electronics module, shown in Figure 1-14.
Figure 1-14
RS-232 Board