Hypertherm HPR800XD Auto Gas Rev.2 - Manual (Page 355)

Appendix B – CnC interfACe protoCol
HPR800XD Auto Gas – 806500 b-21
Error codes
ID Name Description
000 NO ERROR System is ready to run.
009 FLOW SWITCH TEST
When the pump is restarted after a pump timeout (30 minutes
without a start signal) the system will test the flow switch to make
sure there is sufficient flow before firing the torch.
011 NO_ACTIVE_PROCESS The power supply receives an invalid current setting from a CNC.
012 TEST IN PROGRESS One of the gas test modes is running.
013 TEST PASSED The test completed successfully.
014 CUT GAS CHANNEL #1 FAIL The gas pressure is dropping on channel #1, indicating a leak.
015 CUT GAS CHANNEL #2 FAIL The gas pressure is dropping on channel #2, indicating a leak.
016 PLASMA RAMP-DOWN FAIL Pump output has exceeded 200 psi.
017 SHIELD RAMP-DOWN FAIL Shield pressure did not decrease in the allotted time.
018 PUMP OVER PRESSURE Pump output has exceeded 13.79 bar (200 psi.)
020 NO PILOT ARC
No current detected from chopper at ignition and before
1-second timeout.
021 NO ARC TRANSFER No transfer signal detected before 500-msec timeout.
024 Primary
224 Secondary LOST CURRENT CH1
After transfer, lost the chopper current signal.
025 Primary
225 Secondary LOST CURRENT CH2
After transfer, lost the chopper current signal.
026 Primary
226 Secondary LOST TRANSFER
After transfer, lost the transfer signal.
027 Primary
227 Secondary LOST PHASE
When main contactor is engaged, no “phase OK” input.
028 Primary
228 Secondary LOST CURRENT CH3
After transfer, lost the chopper current signal.
030 GAS SYSTEM ERROR A failure has occurred in the gas system.
031 Primary
231 Secondary START LOST
Start signal was removed before steady-state operation.
032 HOLD TIMEOUT Hold signal was applied for longer than 60 seconds.
033 PRE CHARGE TIMEOUT
Gas console was not able to charge the gas lines to the correct
pressure.
034 Primary
234 Secondary PRE CHARGE TIMEOUT
Gas console was not able to charge the gas lines to the correct
pressure.
042 LOW NITROGEN PRESSURE
Nitrogen gas pressure under lower limit of 2.07 bar (30 psi) –
cutting, 0.34 bar (5 psi) – marking
044 LOW PLASMA GAS PRESSURE
Gas pressure under lower limit of 0.34 bar (5 psi) – pre-flow
3.45 bar (50 psi) – cutflow (cutting) 0.34 bar (5 psi) – cutflow
(marking).
045 HIGH PLASMA GAS PRESSURE Gas pressure over upper limit of 7.58 bar (110 psi).
046 LOW LINE VOLTAGE Line voltage is under lower limit of 102 VAC (120 VAC -15%).
047 HIGH LINE VOLTAGE Line voltage is over upper limit of 138 VAC (120 VAC +15%).
048 Primary
248 Secondary CAN ERROR
An error occurred with the CAN communication system.
050 Primary
250 Secondary START ON AT INIT
Start signal input is active during power-up.
053 LOW SHIELD GAS PRESSURE Gas pressure is under lower limit of 0.14 bar (2 psi).