Placement of the secondary power supply, Placement of the secondary power supply -12 – Hypertherm HPR800XD Auto Gas Rev.2 User Manual
Page 52
InstallatIon
3-12
HPR800XD Auto Gas –
806500
Placement of the secondary power supply
•
Place the power supply in an area that is free of excessive moisture, has proper ventilation
,
and is relatively clean.
The components of the plasma system are not intended to be exposed to rain or snow.
Allow 1 m (3 ft) of space
on all sides of the power supply for ventilation and service.
• Cooling air is drawn in through the front panel and is exhausted through the rear of the unit by a cooling fan.
Do not place any filter device over the air intake locations, which reduces cooling efficiency and VOIDS THE
WARRANTY.
• Do not place the power supply on an incline greater than 10°, to prevent it from toppling.
B
DANgER
ElEctRIc SHock cAN kIll
R
emove all electrical connections to
the
power supply before moving or positioning. transporting
the
unit can cause personal injury and equipment damage.