Placement of the chiller, Placement of the chiller -17 – Hypertherm HPR800XD Auto Gas Rev.2 User Manual
Page 57
InstallatIon
HPR800XD Auto Gas –
806500
3-17
Placement of the chiller
• Place the chiller in an area that is free of excessive moisture, has proper ventilation, and is relatively clean.
The components of the plasma system are not intended to be exposed to rain or snow. Allow 1 m (3 ft) of
space on all sides of the chiller for ventilation and service.
• Cooling air is drawn in through the
side and rear panels
and is exhausted through the
top
of the unit by a
cooling fan.
• Do not place the cooler on an incline greater than 10° (with the wheels locked) to prevent it from toppling.
• Refer to the manual that came with your chiller for operation and maintenance information.
Note: The chiller shown below is made by PolyScience and sold by Hypertherm
D