Verilink WANsuite 6x30 (34-00315.B) Product Manual User Manual
Page 117
V T 1 0 0 I n t e r f a c e
4-19
Figure 4.16
Span Endpoint Maintenance Screen
The Span Endpoint Maintenance parameters are described below.
L oop b ack Typ e
Specifies loopbacks for the associated segment endpoint.
Values: No Loopback, Normal Loopback
Default: No Loopback
L o op b ack T im eo u t
Specifies the timeout value in minutes for loopbacks initiated at segments
endpoints contained in the associated unit. A value of 0 disables the timeout.
T ip R in g
Indicates the state of the tip/ring pair at the associated segment endpoint.
P ow er S ou rce
Indicates the DC power source being used by the associated unit.
R estart E n d p oin t
Enables the manager to trigger a soft restart of the SHDSL line at the
associated segment endpoint. The manager may only set this object to the
“restart” value to initiate a restart. The agent will perform a restart after
approximately 5 seconds, and restore the object to the “ready” state.
Values: Ready, Restart
Default: Ready
Selecting the “Performance” prompt on the Span Endpoint Details screen will
display the screen shown in Figure 4.17.