Verilink WANsuite 6x30 (34-00315.B) Product Manual - Manual (Page 138)

4-40 W A N s u i t e 6 x 3 0
equal cost multipath routing where packets to a single destination can be sent
via more than one interface simultaneously.
Figure 4.37 IP Gateway Screen
RIP Parameters
R IP E n a b le Globally enables RIP 1, RIP 2, or No RIP. Default is RIP 2.
Values: Disable, Enable RIP1, Enable RIP2
Default: Enable RIP2
R IP Tru st N eigh b ors Globally enables the trusted neighbors feature. If there is a list of trusted
neighbors in an IP Gateway, only RIP packets coming from those trusted
neighbors will be used to build the internal routing table.
Values: Enable, Disable
Default: Enable
R IP In terva l Interval for RIP packet to be sent. Default is 30 seconds.
R IP D o m ain Value representing the RIP domain. Default is 0.
OSPF Parameters
O S P F E n a b le OSPF stands for Open Shortest Path First Routing, which is a shortest-path-
first (SPF) or link-state protocol. OSPF is an interior gateway protocol that
distributes routing information between routers in a single autonomous
system. This Protocol is suitable for complex networks with a large number of
routers. If a large network is involved, OSPF may be the solution for the user.
Values: Disable, Enable
Default: Disable