Verilink WANsuite 6x30 (34-00315.B) Product Manual - Manual (Page 30)

3-2 W A N s u i t e 6 x 3 0
To access the Web Server interface, enter (by typing) the unit’s IP address in
the browser’s Address (or Location) field and press the “Enter” key.
Another method for accessing the Web server configuration screens is to
establish a PPP connection through the unit’s Supervisory port. To use PPP
on the Supervisory port, set up a PC running Windows 9x/NT for Dial-up
Networking with a NULL modem driver, and establish a PPP connection.
Then open your Web browser and direct it towards the Port’s IP address.
Layout of Interface Screens
When you first access the Web Server interface, your browser will display a
screen that is divided into three frames. The upper frame forms a border
across the top of the screen; it identifies the Verilink unit in service and
displays the hardware and software revision and serial numbers under which
the unit is operating.
The area beneath the upper frame is divided into two side-by-side frames. The
frame on the left side, the navigation pane, depicts a hierarchical “tree”
structure used to navigate through the various interface screens. Each
“branch” on the tree guides you to more specific upper-level information
about the unit and its configuration. Note that the Interfaces, Applications, and
Utilities branches do not link to an actual displayed page
−
these branches are
simply used to provide structure for navigation. The frame on the right side of
the screen displays the configuration screen. The screen captures throughout
this chapter show only the configuration portion of the screen, except in the
case of the Unit screen, which shows all three frames. The Unit screen
represents the top of the navigation tree.
Unit Screen
The first screen displayed by the unit’s Web Server interface is the Unit
screen (Figure 3.1). This screen lets you view and set specific information
about the unit in service.